Can You Reuse Metal Fence Posts?
Galvanized metal fence post are cheap, probably under $10 each. Be sure to use safety glasses chipping concrete. Also if you reuse them clean them up and repaint especially below ground since concrete is so acidic.

.

In this way, can you reuse old fence posts?

Re: Reusing old fence post holes Take a sledge, break the old concrete off the old post, save it, if the post is still good enough to reuse, great, use it.

Also Know, how do you fix a rise in a fence post? Fortunately, there is an easy vinyl fence repair for frost-heaved posts. Pull the posts out of the ground, and then dig the post hole deeper so it's below frost depth. (If you're doing this repair in winter, you may need special equipment to dig into frozen soil, such as a pickaxe or heater.)

Just so, how do you redo a fence post?

Steps

  1. Disconnect the post from any fence panels or wires.
  2. Dig a hole around 1 side of the fence post.
  3. Rock the post back and forth to break up the surrounding ground.
  4. Lift loose posts up by hand.
  5. Use a jack to remove your post if it's stuck.
  6. Clear the hole of any post and concrete remains.

How do you extend a wooden post?

How to Install Extended Posts on a Wood Fence

  1. Measure and cut a 4-by-4-inch extension post to the desired length.
  2. Cut two sections from the 1-by-4-inch lumber to act as braces for two sides of where the old post and extension will be joined.
  3. Cut two braces from the 1-by-6-inch lumber to match the lengths of the other two braces.
Related Question Answers

How do you get a post out of the ground?

Steps
  1. Tie your rope several times around the end of the plank.
  2. Tie the other end of the rope several times around the base of the T post, as close to the ground as possible.
  3. Set up your fulcrum about 6 inches (15.2 cm) from the base of the T post, and put the plank on top of it.
  4. Push down on the far end of the plank.

How do you take down a fence?

To remove the fencing and reduce everything to a frame, use your hammer on each piece of fencing, first to know the wood away from the frame, then use the claw end to pull out the nails. Stack the pieces of fence. Once you've finished you'll be left with horizontal pieces of wood and the vertical fence posts.
Maya Lin-Takahashi

Maya Lin-Takahashi

Consumer Tech & Gadget Reviewer

Maya is a hardware enthusiast who tests and reviews smart home devices, smartphones, wearables, and audio gear. She focuses on practical consumer value and build quality.