How Do I Remove My Netatmo Camera?

How do I remove my Netatmo camera?

Smart Outdoor Camera with and without Siren

1. Smart Outdoor Camera with Siren.
2. Setup – Installation.
3. Storage (SD card – Dropbox – FTP)
4. Apple HomeKit.

Where to mount Netatmo Rain Gauge?

Location. The Smart Rain Gauge should be placed horizontally, if possible 50 to 150 cm above the ground, and at a distance equal to the height of the surrounding obstacles (by default 3m).

How does Netatmo weather station connect to HomeKit?

Once the Station is installed, to activate HomeKit on your Weather Station, open the Netatmo Weather app on an iPhone or iPad / iPod touch:

1. Go to Settings> Manage my Home.
2. Select the room where the Main Station module is located.
3. Click on the main module.
4. Click on “Configure HomeKit”.

How do I reset my Netatmo outdoor module?

Power Specifications

1. Disconnect and reconnect your indoor module. Check that the LED flashes 3 times.
2. Force quit and restart the Netatmo Weather application on your smartphone. The Station can take up to 10 minutes to reconnect.

How do I connect my Netatmo presence to WIFI?

Steps

1. Reboot your router and your smartphone.
2. Reboot the Camera (at the fuse).
3. Open the Netatmo Security App and from the settings choose “Install new products”.
4. If you are using an iOS device, be sure your smartphone is connected to a 2.4GHz network.
5. If you try to install the Camera on a Wi-Fi repeater:

How do I reset my Netatmo presence?

Go to phone Settings > Applications ( Apps ) > Presence > Clear data.

How do you mount a Netatmo wind gauge?

It is recommended to place it about 1 m / 4 ft. above the top of your roof. The Wind Gauge should be placed horizontally and the arrow (there’s one at on the top and one in the bottom) must be pointing to the North. You can use your smartphone’s compass app to check that when you install your Wind Gauge at home.

How does Netatmo rain gauge work?

1.1 How does it all work? The outdoor module (small) wirelessly sends its measurements to the indoor module (large) using a radio signal. Using your Wi-Fi access point, the indoor module then sends both its own measurements and the outdoor module’s measurements to your personal online Netatmo account.