How Do I Reset My Maytag Maxima Dryer?
If the Dryer Needs to Be Reset Simply Because the Cycle Needs to Be Changed, Stopped or Altered, Press “Power/Cancel” Once to Cancel the Current Cycle. Select...
If the dryer needs to be reset simply because the cycle needs to be changed, stopped or altered, press “Power/Cancel” once to cancel the current cycle. Select the new desired cycle, followed by any modifiers and cycle options. Then press “Start/Pause” to begin the new cycle.
What causes a Maytag dryer to stop heating?
If your Maytag dryer is not heating, it is possible that it is not being supplied with the proper voltage. Most electric dryers require two legs of 120 volts AC that is equal 240 volts. If one leg of voltage is shut off by a tripped breaker or blown fuse, the dryer may be able to run but it will not heat.
no, there is no reset button for this model at all. Make sure that the unit is getting power to ita nd if so then you probably have a bad thermal fuse, or bad door switch. To check the door switch just open the door and push on the door switch to make sure it still clicks.
Where is the thermal fuse located in a Maytag dryer, model?
Your dryer has two thermal fuses. One thermal fuse is located on the heating element housing located underneath the drum and the other thermal fuse is located on cover of the blower assembly. I added images below with instructions. _NOTE: Disconnect the power cord from the power source before servicing your dryer._You can view and order parts from
What to do if your electric dryer fuse is blown?
When the thermal fuse is blown in an electric dryer, the controls light up but the drive motor won’t run. You can’t reset the thermal fuse; if it’s blown, you have to replace it with a manufacturer-approved replacement part. Before you begin, wear work gloves to protect your hands. Unplug the dryer. Remove the screws from the back panel.
How do you replace a thermal fuse on a Kenmore dryer?
Remove the back panel from the dryer and set it aside. Pull the wires off of the thermal fuse. Remove the mounting screw using a 1/4″ nut driver. Pull the fuse off of the blower housing. Position the new fuse and secure it with the screw. Push the wires onto the connection spades on top of the new thermal fuse.
Where can I find parts for my dryer?
An error occurred while retrieving sharing information. Please try again later. Click for more information. Find parts for your model.
Chloe Bennett explores the intersection of pop culture, streaming entertainment, digital trends, and contemporary lifestyle. Her weekly commentary reaches thousands of culture enthusiasts.
