How Do You Reset Particle Argon

To factory reset, hold down the MODE button and tap RESET. The status LED will blink: Magenta (red and blue at the same time, safe mode) Yellow (DFU mode)

How do you reset a particle electron?

To enter Firmware Reset Mode: Hold down BOTH buttons. Release only the RESET button, while holding down the MODE button. Wait for the LED to start flashing green or white (it will flash magenta, then yellow first)

How do you program particle argon?

1. Set up your Argon. For a short (~4 min) overview of what the Argon setup process looks like, watch the video below.
2. Open the Web IDE. To program your Argon, open a new browser tab and go to the Web IDE. …
3. Load the Blink example. Click on Blink an LED on the left side of the page. …
4. Target your device. …
5. Compile your code & flash.