How to Fasten Lvl Beams Together

The TrussLOK Engineered Wood Fastener has been designed specifically for use in joining multiple-ply engineered wood beams (LVL, LSL & PSL). Using a stan- dard corded or cordless 1/2″ low speed/high torque drill, install screws into the side of the outermost ply.

Should you glue LVL beams together?

LVL beams are long pieces of lumber that are usually used for grand windows and wide doorways. With wooden LVL beams, you must use extremely adhesive glue; not using strong enough glue will cause your wooden structures to collapse.

Can you nail into a LVL beam?

The wall you are adding is a non bearing wall that will not hinder the bearing capacity of the beam. Nail it in place using standard nailing practice. In other words, don’t load it up with no more nails than you need, one nail staggered every 16″, 2 on the ends.

Can you drill holes in LVL beams?

Whenever possible, avoid drilling vertical holes through LVL beams unless the beam width is at least 3-1/2 inches. Prior to drilling any vertical holes, an engineer or architect qualified in wood design should be consulted.

How far can a double 11 7 8 LVL span?

As per general thumb rule and guidelines, a double 3 1/2″ × 11 7/8″ lvl beam can allow span upto 20 feet far distance used for residential building or projects.

What glue is used in LVL?

The properties of the laminated veneer lumber (LVL) composed of the boiled veneer of Rubberwood (Hevea brasiliensis) using polyvinyl acetate (PVAc) adhesives in various cold-pressing time and various conditioned time with loaded and unloaded were studied.

Can I make my own LVL beam?

Although you can attempt to make do-it-yourself laminated beams or buy used glulam beams for sale, it is highly recommended that you purchase them from a reliable source. If you make just one small mistake when trying to make your own glulam, you can severely damage your entire project.

How thick is a 2 ply LVL?

How thick is a 2 ply lvl:- thickness of a 2 ply lvl beam is 90mm or 3 -1/2 inches, which are made of fastening 2 LVL plies of thickness 1- 3/4″ such that 1-3/4″ + 1- 3/4″ = 3 -1/2″, together on site with super stronger glue.

What size LVL Do I need to span 16 feet?

What size lvl beam for a 16 foot span:- as per general thumb rule, for a 16 foot span, size of LVL beam or GLULAM should be 7 to 8 inches deep and 3 inches wide, thus you need something like a 7-8″ GLULAM or LVL to span upto 16 feet and can use simple 2×10 dimensional lumber at 16″ apart from centre as floor joists

What is a 2 ply LVL beam?

Each 1¾” LVL is referred to as a ply. Thus, two 1¾” LVL’s is considered a two-ply assembly. When greater than 1¾” thickness is required for strength, it is necessary to fasten the multiple LVL plies together to act as a single unit.