How to Use a Portable Table Saw

How to Set Up a Portable Table Saw
Secure Your Saw. Remove the Throat Plate. Install the Blade. Install the Riving Knife. Attach the Anti-Kickback Device. Attach the Blade Guard Assembly. Install the Throat Plate. Locate the Fence.

Which way should I feed wood to a table saw?

Know the recommended feed direction on a table saw. Most operating manuals specify that you feed the workpiece into the saw blade against the direction of rotation (i.e., workpiece B). This implies you introduce the wood into the blade as the teeth are going downward.

What should you never use a table saw for?

The woodworker should always wear safety glasses and hearing protection, but appropriate clothing should also be considered. Loose fitting clothing, neckties, and jewelry are all hazards to avoid when using a table saw.

Which side do you cut on table saw?

To get the cleanest cut possible remember these tips: Whenever you run wood through a Table saw, always make sure that your finished side is up. Do the exact opposite when you are using your Power saw. The finished side of your wood must be at the bottom.

How do you keep wood against fence on table saw?

Use featherboards to hold wood against the fence for a straight cut. When it’s tough to keep a board aligned with the fence, pull out a featherboard for smooth, straight cuts. Featherboards have a series of wooden “fingers” that hold wood tightly against the saw fence.

Can you rip 2×4 on a table saw?

You can rip 2 x 4 on a table saw effectively provided you set the rip fence correctly, use proper technique and use the right tools. The proper technique while ripping a 2×4 is to apply pressure in three directions, that is, against the rip fence, forward (for pushing the wood), and downwards for keeping the wood flat.

What are 3 safety rules for a table saw?

Safety Rules

Safety glasses and hearing protection are required. Never saw freehand. Never clear small pieces while blade is moving. Never adjust saw or setup while saw is running.

What are the two biggest dangers when using a table saw?

In the table saw, the hazards are the rotating saw blade and its sharp teeth. Neither of these can be eliminated and still yield a working saw. Accordingly, if we are to reduce the danger level on a typical saw, we must reduce the exposure of the operator to the hazard presented by the saw’s blade.

When cutting wood should the side be up or down?

Cut Wide Boards With the Best Side Down

Splinters and tear-outs occur where the blade breaks through the wood. That’s the bottom side when plunge-cutting narrow boards, so it’s best to cut narrow boards with the “show” side face up.

Should table saw fence be parallel to blade?

Rob Johnstone: For regular ripping operations, table saw fences should be perfectly straight and perfectly aligned — parallel — with the saw blade. (No toe-in or toe-out.)